Publicidad
Idiomas disponibles
Idiomas disponibles
Interfaz de usuario – Configuración del sistema
If you are using a DMX console and other automated lighting products compatible with Art-Net, the Ethernet
network can serve as the link for DMX control. All DMX controls can be sent over the Ethernet cable. Multiple
universes are possible.
About the DMX menu
DMX Feature What can be done?
DMX Address Before a projector can execute DMX commands, a unique address (named DMX address)
should be given to the projector.
This address can vary from 1 to 512.
DMX Mode
Two different modes for DMX are available.
•
•
For the full mapping of each used channel, refer to the DMX chart in the appendices. See
"Tabla DMX", página
DMX Monitor
If a DMX device is connected, the settings per channel can be displayed via the Monitor
button.
Art-Net DMX
DMX can be sent via the Ethernet connector to the projector instead of the classic DMX
connector. This function can be enabled or disabled. Art-Net is generally used when more
than 512 addresses are used in your setup.
DMX
Note: DMX Universe can only be used when Art-Net DMX is enabled.
Universe
If Art-Net is enabled, you can specify which DMX universe this projector belongs to.
DMX auto
The projector can be forced to shut down after a certain time-out period (in minutes) if no
power down
DMX signals are available.
Front XLR
If available, the power of the XLR connector on the front side of the projector can be
connector
enabled and set to a desired value.
How to set up DMX?
1.
In the main menu, select System Settings → Communication → DMX.
Imagen 10–27 Communication menu, DMX
The DMX menu is displayed.
132
R5913592ES /03 Njord and HODR
Basic: A basic configuration where 2 channels are implemented.
Extended: A full configuration, spread over 14 channels.
183.
Publicidad
