Garland GROOVER 7A3 Manual De Instrucciones página 44

English
5. If the diameter of the spoke end face is 1mm larger
than that of the worm wheel end face, it is necessary
to add an adjustable pad. If not, it is not necessary.
6. Finally, tighten the screws.
6.2.2. ASSEMBLY OF THE ACCESSORIES CONNECTOR
BUSHING
1. Remove the four M8 nuts.
2. Connect the accessory socket and retighten the
M8 nuts.
6.2.3. HANDLEBAR MOUNTING
1. Remove the two M8 nuts indicated in the image
and loosen the other two.
2. Rotate the clamping plates 180º
44/172