Garland GROOVER 7A3 Manual De Instrucciones página 53

Operation
Check that there are no loose parts
Check the condition of the wheels
Check the engine oil level and
transmission oil level
Change the engine oil
Change the transmission oil
Clean the air filter
Check the spark plug
- Once dry, moisten it with 2 drops of oil (if you wet
the filter with too much oil the machine cannot
start).
- Install the filter on the machine.
- Put on the protective cap.
Note: The engine should never function without
the air filter installed.
8.2.2. CHANGING THE ENGINE OIL
Perform the oil change only while the engine is still
hot.
WARNING! You must not throw old oil in a
pipeline network or on the Earth. The contamination
of groundwater and water tables is subject to heavy
fines. There are special collection places at service
stations. If not, any municipal authority will give you
the relevant information.
Note: You have two procedures at your disposition to
empty the engine oil. You can drain the oil
by loosening the drain screw (Y2) located at the base
of the filling canal or you can use the Garland engine
•
•
•
•
oil cleaner (ref.: 7199000020, not included with the
machine, which can be found at your nearest Garland
dealer) and suck the oil through the filling tube (Y1) of
the machine. For easy implementation, cleaning and
safety we recommend that you pick up the oil.
To change the oil:
- Place the machine on a flat, horizontal and
uncluttered surface.
Empty the engine oil:
- If it sucks the used oil: remove the engine oil plug
(Y1) and vacuum the motor oil by inserting the
Garland vacuum cleaner tube (REF.: 7199000020,
not included with machine) to the bottom.
- If you choose to empty the drain (Y2) through the
drain plug, please note the trajectory that the oil
53/172
•
•
•
English
•
•
Y1
Y2