Garland GROOVER 7A3 Manual De Instrucciones página 48

English
- That the guard is properly attached to the machine.
- That there are no fuel leaks.
- The crankcase oil and transmission level.
- The air filter is clean.
Tighten, repair or replace everything you need
before using the machine.
Do not use any accessory on this machine outside of
those recommended by Garland since its use could
result in serious injury to the user, machine, and the
people, animals and things close to the machine.
6.4.2. STARTING THE ENGINE
Start the engine carefully, in accordance with the
instructions, and feet away from the milling cutters.
6.4.2.1. COLD-STARTING THE ENGINE
Place the machine on a flat and stable surface to start
it.
1. Turn the machine's power button (18) to the "ON"
position.
2. Place the start / stop lever (3) in start position "I".
3. Turn the fuel cock to the open position.
4. Place the air lever in the closed position
5. Place the accelerator lever in the maximum
position.
6. Stand behind the machine and pull the starter rope
until the engine starts.
7. If the machine starts and does not stop, slowly
begin moving the air lever toward the Open air
position
8. Adjust the appropriate number of revolutions with
the throttle lever.
9. Allow the engine to warm up for a few minutes
before starting to use the machine.
6.4.2.2. ARRANQUE CON EL MOTOR CALIENTE
Colocar la máquina en una superficie plana y estable
para arrancarla.
1. Turn the machine's power button (18) to the "ON"
position.
2. Place the start / stop lever (3) in start position "I".
3. Place the fuel faucet in the Open position.
. 4. Place the air lever in the Open position
(Normal working position)
5. Place yourself behind the machine and pull the
Starter rope until the engine starts.
6. Adjust the appropriate number of revolutions with
the throttle lever.
48/172
.
(normal working position).
Normal working
position