Garland GROOVER 7A3 Manual De Instrucciones página 45

3. Then push down on the height control lever and
then place the handlebar with the stopper positioned
in the groove of the handlebar. (Tip: place the stop in
the middle of the groove).
4. Return the clamping plates to their initial position,
then lightly screw in the two M8 nuts. Push down on
the height control lever and handlebar while tightening
the 4 nuts.
6.2.4 ASSEMBLY OF THE LEVERS
1. Remove the two cotter pins and remove the plastic
plugs from the gear control levers.
Palanca de
control de altura
Tope
45/172
2. Then rotate them slightly and put them back in the
position you see in the image
6.2.5. CHANGE OF HANDLEBAR POSITION
This machine has the possibility of working in two
directions, depending on the type of accessory that
is going to be used. To change the position of the
handlebar, pull the keys and the gear shift levers (9).
Then squeeze the handlebar directional change lever
(7) and move the handlebar only in the direction
shown by the icon. The handlebar can only turn on
one side.
English