Care And Maintenance; General Information - Kärcher MC 130 Manual De Instrucciones

Retaining pin with split pin
1
Towing eye
2
Vehicle chassis
3
Bolt
4
Locking pin
5
2. Attach the towing eye at the front of the vehicle chassis on the
right-hand side.
3. Insert the retaining pin into the towing eye and secure with the
locking pin.
Fitting the towing eye
Note
The towing hook for MC 130 advanced is stored behind the pas-
senger seat on a special holder along with the safety bolts and
safety bracket.
Towing eye
1
Safety bolt with safety bracket
2
Safety chain with safety bracket
3
Towing bolt
4
Holder for towing eye
5
Attached behind the passenger seat
1. Remove the towing eye with locking pin and safety bracket
from the holder.
Locking pin with safety bracket
1
Towing eye
2
Retaining pin with split pin
3
2. Attach the towing eye to the front of the vehicle frame.
3. Insert the retaining pin into the towing eye and secure with the
locking pin.
CAUTION
Risk of damage due to incorrect towing
Only tow the vehicle away at walking speed.
Start up the towing vehicle slowly without jolting.
Fasten the towing rope or towing bar to the towing catch only.
Make sure the steering is working.
1. Release the parking brake spring actuator.
Bypass valves
1
2. Unscrew the bypass valves 3 revolutions (width across flats 24
mm).
3. Attach a towing bar or towing rope to the towing eye.
4. Pull the vehicle slowly onto the transporting vehicle.
5. Close the parking brake spring actuator and bypass valves.

Care and maintenance

DANGER
Crush hazard
When working under raised attachments, ensure these are al-
ways mechanically locked (shimming).
1. Switch off the appliance and remove the ignition key prior to
performing any cleaning or maintenance tasks on the device,
replacing parts or switching over to another function.
2. Always disconnect the battery before working on the electrics.
English
Towing the vehicle

General information

85