Malfunction
Emergency operation hydraulic valve
Manual pump
1
Ballcock - normal operation
2
(A) - (F) Knurled screws
1. Unlock the cover screws (3x) by turning to the left.
2. Remove the cover.
Note
A pipe is required for operating the manual pump and this is lo-
cated at the side behind the driver's seat.
Order no.
Description
6.422-522.0
LED working light
9.654-350.0
Wiper arm
9.654-351.0
Wiper blade
9.989-357.0
Signal horn
Cause
Low fuel level.
Battery is not charging.
Regeneration process required.
Service required.
Spare parts list
Remedy
Refill fuel.
Bleed fuel system if the tank has been run dry.
Call Customer Service.
Perform regeneration, see Start regeneration.
Have Customer Service service the vehicle.
a The service indicator must be reset by Customer
Service.
Raise the waste container/attachment frame
1. Screw in the knurled screws (B, E, F).
2. Actuate the manual pump (1).
Waste container/attachment frame raises.
3. Slowly unscrew knurled screw (F).
Waste container/attachment frame lowers.
4. Completely unscrew the knurled screws.
Original position is restored.
Raising the front power lift/suction mouth
1. Screw in the knurled screws (A, D, F).
2. Actuate the manual pump (1).
Front power lift/suction mouth raises.
3. Slowly unscrew knurled screw (F).
Front power lift/suction mouth lowers.
4. Completely unscrew the knurled screws.
Original position is restored.
Releasing the parking brake spring actuator
1. Move the ballcock (2) to the horizontal position.
2. Screw in the knurled screw (C).
3. Actuate the manual pump (1).
Spring actuator releases.
4. Move the ballcock to the vertical position.
5. Unscrew in the knurled screw (C).
Spring actuator is actuated (original position).
Accessories and spare parts
Only use original accessories and original spare parts. They en-
sure that the appliance will run fault-free and safely.
Information on accessories and spare parts can be found at
www.kaercher.com.
Quantity
2
1
1
1
English
Illustration
97