Drive Mode; Parking The Vehicle - Kärcher MC 130 Manual De Instrucciones

Air recirculation lever
1
Ventilation nozzles
2
2. Adjust the volume and direction of the airflow at the ventilation
nozzles.

Drive mode

The main switch must be switched on.
1. Sit down on the driver seat and fasten the seat belt.
2. Insert the ignition key into the ignition lock.
3. Set the travel direction lever into central position (neutral posi-
tion).
4. Turn on the ignition.
Warning lights for charge control and motor oil pressure must
be on.
5. Start the motor.
Warning lights for charge control and motor oil pressure must
go out; if not, switch off the motor and rectify the error.
6. At ambient temperatures below 0 °C: Warm up the vehicle at
a low motor speed until the "Hydraulic oil temperature too low"
warning light goes out.
Selecting the travel direction
Travel direction lever
1
1. Press the travel direction lever towards the steering wheel and
in the desired driving direction.
The travel direction is shown in the display.
2. Bring the travel direction lever into the neutral position (middle
position).
The engine idles.
3. Press the travel direction lever to the end position.
4. Select the transport speed (between tortoise 20 km/h and hare
40 km/h).
The symbols are shown in the display.
5. Regulate the travel speed using the accelerator pedal.
Start motor
ATTENTION
Caution
The vehicle must be at a standstill and the travel direction lever
in the NEUTRAL POSITION before changing the travel speed.
Operating error
If the travel direction lever is in the forwards or reverse position
when changing speed, the tortoise/hare symbol on the display
will change but the travel speed will not be changed.
WARNING
Risk of accident
Do not drive while the waste container is raised.
CAUTION
Risk of accident
Do not let go of the accelerator pedal abruptly during driving. The
vehicle will be braked when the accelerator pedal is released.
The vehicle will be decelerated to a lesser extent when the accel-
erator pedal is released in transport mode rather than in operat-
ing mode.
CAUTION
Risk of damage
Make sure that the vehicle does not become stuck when driving
over obstacles.
Drive over obstacles up to 150 mm slowly and carefully at an an-
gle of 45°.
Obstacles above 150 mm may only be driven over using a suita-
ble ramp.
CAUTION
Risk of accident
When driving on public roads for transport purposes (and not
when cleaning of public roads), switch off the PTO and close the
lowering choke for the front power lift.
1. Switch off PTO.
2. Carefully depress the accelerator pedal.
3. Control the travel direction using the steering wheel.
1. Release the accelerator pedal.
The vehicle brakes automatically and comes to a standstill.
2. For a stronger braking effect or in case of an emergency, ac-
tuate the brake pedal.
The Tempomat is only active in Working mode.
Activating Tempomat
1 Select the desired working speed using the accelerator.
2 Press function key F 8.
Tempomat is activated.
Deactivating Tempomat
1 Press the brake pedal or function key F 8.
Function key F 9 (Resume Tempomat) activates the previously
set speed.
1. Stop the vehicle.
2. Bring the travel direction lever into the neutral position (middle
position).
Note
In this position, the parking brake is automatically actuated; the
vehicle does not move.
3. Lowe the front power lift.
If a sweeper is used:
4. Raise the side brushes.
5. Switching off the "eco" function
or
 Switch off the water pump.
 Wait 20 seconds.
 Switch off the suction fan.
 Switch off the PTO.
All sweeping functions are deactivated.
6. Allow the engine to run in idle mode for 1 to 2 minutes.
English
Driving
Stopping
Tempomat

Parking the vehicle

73