Descargar Imprimir esta página

Snap-On TECHANGLE STEEL ATECH2FS100 Manual Del Usuario página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

00
100.0
FT-LB
Target Torque Screen
ENTER button
PSET 01
03
100.0
FT-LB
Preset Torque Screen
Note: To select a stored PSET or manual target torque or angle mode, repeatedly press ENTER
button until desired PSET or manual mode is displayed.
Adding an Angle Preset
1. From target angle screen, press and hold UNITS
2. ADD PRESET confirmation screen is displayed. Highlight
buttons then press ENTER
a PSET.
3. MINIMUM ANGLE screen is displayed. MINIMUM ANGLE is target value at which green progress
lights, audible alert and vibrator turn on. Initial MINIMUM ANGLE value is value from target angle
screen. MINIMUM ANGLE can be set from 0 to 360° by pressing UP
desired target angle value has been set, press ENTER
4. MAXIMUM ANGLE screen is displayed next. MAXIMUM ANGLE is angle value above which red
progress lights turn on. Initial MAXIMUM ANGLE value will be MINIMUM ANGLE plus 4%.
Maximum angle value can be set to any value greater than MINIMUM ANGLE by pressing
UP
/DOWN
5. BATCH COUNT screen is displayed next. Default value is zero. Batch count range is 0 to 99. Press
UP
/DOWN
time target angle is reached if a batch count of zero is entered. Mode Count decrements if a non-
zero batch count is entered and resets to batch count value when count reaches zero. Once
desired value has been set, press ENTER
6. PSET target screen is displayed labeled with next available PSET number from 01 to 10.
7. To enter additional angle presets, repeatedly press ENTER
displayed and repeat steps above.
00
90°
Target Angle Screen
ENTER button
PSET 02
04
90°
Preset Angle Screen
UNIT
ADD PRESET
button
held
YES
NO
UP/DOWN buttons
ADD PRESET
YES
NO
button.
buttons. Once desired value has been set, press ENTER
buttons to increment/decrement batch count. Mode Count increments each
UNIT
ADD PRESET
button
held
YES
NO
UP/DOWN buttons
ADD PRESET
YES
NO
UP/DOWN buttons
ENTER
button
MINIMUM TORQUE
100.0
FT-LB
ENTER button
U
button for 3 seconds.
YES
NO
menu selection returns to main menu without adding
button.
button.
UP/DOWN buttons
ENTER
button
MINIMUM ANGLE
90°
ENTER button
9
UP/DOWN buttons
ENTER
button
MAXIMUM TORQUE
104.0
ENTER
button
BATCH COUNT
3
UP/DOWN buttons
menu selection using UP
/DOWN
button.
button until target angle screen is
UP/DOWN buttons
ENTER
button
MAXIMUM ANGLE
94°
ENTER
button
BATCH COUNT
4
UP/DOWN buttons
FT-LB
/DOWN
buttons. Once

Publicidad

loading

Este manual también es adecuado para:

Techangle steel atech3fs250Techangle steel atech4rs600