Snap-On TECHANGLE STEEL ATECH2FS100 Manual Del Usuario página 7

6. Pressing ENTER
default, "OFFSET IN USE" message will be displayed on target screen.
00
100.0
FT-LB
M
Target Screen
00
OFFSET IN USE
100.0
FT-LB
M
Note: Head length entered is offset length measured from center of drive to center of fastener.
Use of Negative Offsets
Note: Enter a negative value for offset when used in reverse direction.
When length of an offset is negative, maximum fastener target is limited by following formulas:
100 ft-lb wrench:
Maximum Target Torque =
offset * 8 + 100
Offset Max Target
-1" 92 ft-lb
-2" 84 ft-lb
-3" 76 ft-lb
-4" 68 ft-lb
Note: When using a negative offset, entering a target torque greater than maximum values above
may cause an overtorque error before reaching fastener target torque and possibly damage
wrench.
button after length is set returns to main menu. If length is changed from
ENTER
EXIT
button
LANGUAGE
held
SET HEAD LENGTH
SHOW DATA
M
UP/DOWN buttons
EXIT
LANGUAGE
SET HEAD LENGTH
SHOW DATA
M
ENTER button (after length change)
250 ft-lb wrench:
Maximum Target Torque =
offset * 12 + 250
Offset
-1"
-2"
-3"
-4"
ENTER
SET HEAD LENGTH
button
0.000
M
M
UP/DOWN buttons
Max Target
238 ft-lb
226 ft-lb
214 ft-lb
202 ft-lb
6
UNITS
button
SET HEAD LENGTH
0.0
IN
M
M
UP/DOWN buttons
600 ft-lb wrench:
Maximum Target Torque =
offset * 14 + 600
Offset Max Target
-1" 586 ft-lb
-2" 572 ft-lb
-3" 558 ft-lb
-4" 544 ft-lb
MM