Descargar Imprimir esta página

Snap-On TECHANGLE STEEL ATECH2FS100 Manual Del Usuario página 18

Publicidad

Idiomas disponibles

Idiomas disponibles

Advanced Configuration
Accessing Advanced Configuration
Advanced configuration is accessed from
1. From target torque or angle screen, press and hold ENTER
2. Highlight
CONFIGURE
3. Press ENTER
Menu Selections:
EXIT - Exits Configure menu and returns to target torque or angle screen.
MODE SETUP - Displays wrench mode setup menu.
CALIBRATION - Displays wrench calibration menu (password protected).
SET DATE/TIME - Displays clock date and time entry screens.
SET CAL INTRVAL - Displays calibration interval setup screen (requires clock date and time
setup).
4. To exit Configure menu and return to target torque or angle screen, press ENTER
EXIT
menu selection is highlighted.
100.0
FT-LB
Target Screen
Note: All user configurable settings are stored in non-volatile memory and are retained while power
is off.
Mode Setup
Mode setup menu allows user to enable/disable Torque THEN angle mode.
1. From Configure menu, press ENTER
2. Mode Setup menu is displayed.
Menu Selections:
EXIT - Exits Mode setup menu and returns to Configure menu screen.
THEN DISABLED - Displays THEN Mode enable/disable screen.
3. Use UP
/DOWN
4. Press ENTER
EXIT
MODE SETUPs
CALIBRATION
SET DATE/TIME
Configure menu
Enable/Disable Torque THEN Angle Mode
This function will allow user to enable or disable Torque THEN Mode.
1. From Mode Setup menu, use UP
(factory default) then press ENTER
2. TQ THEN ANGLE enable/disable screen is displayed.
3. Use UP
/DOWN
4. Press ENTER
menu selection using UP
button to display Configure menu.
ENTER
00
EXIT
button
LANGUAGE
held
SET HEAD LENGTH
SHOW DATA
M
UP/DOWN buttons
CLEAR DATA
CYCLE COUNT
SETTINGS
CONFIGUREs
buttons to highlight menu selections.
button while
EXIT
menu selection is highlighted to return to Configure menu.
ENTER
EXIT
button
THEN DISABLED
Mode Setup menu
buttons to select ENABLE or DISABLE selection.
button to accept selection and exit to Mode Setup menu.
CONFIGURE
menu selection on main menu.
/DOWN
ENTER
EXIT
button
MODE SETUPs
CALIBRATION
SET DATE/TIME
Configure menu
button while
MODE SETUP
/DOWN
buttons to highlight
button.
17
button for 3 seconds.
buttons.
selection is highlighted.
THEN DISABLED
button while
selection

Publicidad

loading

Este manual también es adecuado para:

Techangle steel atech3fs250Techangle steel atech4rs600