Descargar Imprimir esta página

Snap-On TECHANGLE STEEL ATECH2FS100 Manual Del Usuario página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

Advanced Settings
Accessing Advanced Settings
Advanced settings are accessed from
1. From target torque or angle screen, press and hold ENTER
2. Highlight
SETTINGS
3. Press ENTER
Menu Selections:
EXIT - Exits Settings menu and returns to target screen.
SHOW INFO - Displays wrench operational information.
SLEEP TIME - Displays power down interval setup screen.
LCD CONTRAST - Displays LCD contrast setup screen.
KEY BEEP - Displays button press beep enable/disable setup screen.
AUTO BACKLIGHT - Displays auto backlight enable/disable screen to turn on backlight during
measurement.
TOGGLE BACKLGHT - Displays BACKLIGHT
screen.
VIBRATOR CONFIG - Displays vibrator ON/OFF configuration for when target reached.
4. To exit Settings menu and return to target torque or angle screen, press ENTER
EXIT
menu selection is highlighted.
100.0
FT-LB
Target Screen
Note: All user configurable settings are stored in non-volatile memory and are retained while power
is off.
Show Info
Show Info menu selection displays wrench operational information.
1. From Settings menu, press ENTER
2. SHOW INFO screen is displayed.
3. UP
/DOWN
Operational Information:
CAL: Date of last wrench calibration.
ISD: In-Service Date.
TCF: Torque Calibration Factor.
ACF: Angle Calibration Factor.
VER: Software version.
OVR CNT: Overtorque Counter tracks how many times an over-torque event occurred on
wrench (torque >125% of full scale).
TQZ: Torque Zero Offset.
ANZ: Angle Zero Offset.
4. Pressing ENTER
SETTINGS
menu selection using UP
button to display Settings menu.
ENTER
00
EXIT
button
LANGUAGE
held
SET HEAD LENGTH
SHOW DATA
M
SHOW DATA
CLEAR DATA
CYCLE COUNT
SETTINGSs
buttons are used to scroll screen.
button exits Show Info screen and returns to Settings menu.
menu selection on main menu.
/DOWN
button toggle or timeout enable/disable
UP/DOWN buttons
EXIT
ENTER
button
SHOW INFO
SLEEP TIME
LCD CONTRAST
Settings menu
button while
SHOW INFO
12
button for 3 seconds.
buttons.
selection is highlighted.
button while

Publicidad

loading

Este manual también es adecuado para:

Techangle steel atech3fs250Techangle steel atech4rs600