Descargar Imprimir esta página

Snap-On TECHANGLE STEEL ATECH2FS100 Manual Del Usuario página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
UP/DOWN buttons
SLEEP TIME
LCD CONTRAST
KEY BEEP
AUTO BACKLIGHT
ENTER
button
Toggle Backlight Setup
This function will allow user to enable or disable backlight toggle function. If toggle mode is disabled,
BACKLIGHT
button turns on backlight and it automatically turns off after five seconds following any
last button press. If toggle mode is enabled, a BACKLIGHT
it will remain on until next BACKLIGHT
1. From Settings menu, use UP
press ENTER
2. TOGGLE BACKLGHT screen is displayed.
3. Use UP
/DOWN
4. Press ENTER
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
UP/DOWN buttons
LCD CONTRAST
KEY BEEP
AUTO BACKLIGHT
TOGGLE BACKLGHT
Note: Backlight will turn off when wrench powers down either by POWER
time.
Note: If toggle backlight is enabled and backlight is on, backlight will remain on during and after
applying torque.
AUTO BACKLIGHT
ENTER
button
ENABLE
DISABLE
UP/DOWN buttons
AUTO BACKLIGHT
ENABLE
DISABLE
/DOWN
button.
buttons to highlight ENABLE or DISABLE (factory default) selection.
button to accept selection and exit to Settings menu.
ENTER
TOGGLE BACKLGHT
button
ENABLE
DISABLE
TOGGLE BACKLGHT
ENABLE
DISABLE
ENTER
button
button press.
buttons to highlight
UP/DOWN buttons
15
button press will turn on backlight and
TOGGLE BACKLGHT
button press or sleep
selection then

Publicidad

loading

Este manual también es adecuado para:

Techangle steel atech3fs250Techangle steel atech4rs600