Publicidad
Idiomas disponibles
Idiomas disponibles
Viewing Stored Torque and Angle Data
Torque data is stored in memory after each torque cycle if applied torque has reached target value.
Torque and angle data is stored in memory after each angle cycle if applied angle has reached target
value. Memory Indicator is displayed when data is stored in non-volatile memory.
1. To view stored torque and angle data, from target torque or angle screen, press and hold ENTER
button for 3 seconds.
2. Highlight
SHOW DATA
ENTER
button to display Show Data screen. To view stored torque and angle data, from target
torque or angle screen, press and hold ENTER
3. Highlight
SHOW DATA
ENTER
button to display Show Data screen.
4. In Show Data screen, scroll through each stored data record by pressing UP
Example:
02 = Show Data List Counter: TQ = Peak torque value
01 = Show Data List Counter: TQ = Peak torque value: ANG = Peak angle value
5. Pressing ENTER
00
100.0
FT-LB
M
Target Screen
Note: A maximum of 50 data records can be stored in memory. Memory full icon will be displayed when
full. New data will replace oldest record until memory is cleared.
Deleting Stored Torque and Angle Data
1. From target torque or angle screen, press and hold ENTER
2. Highlight
CLEAR DATA
button to display CLEAR ALL DATA screen.
3. In CLEAR ALL DATA screen, highlight
selection to exit without deleting data.
4. Press ENTER
00
100.0
FT-LB
M
Target Screen
menu selection by pressing UP
menu selection by pressing UP
button while on Show Data screen returns to main menu.
ENTER
EXIT
button
LANGUAGE
held
SET HEAD LENGTH
SHOW DATA
M
UP/DOWN buttons
EXIT
LANGUAGE
SET HEAD LENGTH
SHOW DATA
M
menu selection using UP
button after making selection.
ENTER
EXIT
button
LANGUAGE
held
SET HEAD LENGTH
SHOW DATA
M
UP/DOWN buttons
LANGUAGE
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
M
/DOWN
button for 3 seconds.
/DOWN
02:
ENTER
button
TQ: 14.2 FT-LBS
M
UP/DOWN buttons
01:
TQ: 15.3 FT-LBS
ANG: 84°
M
/DOWN
YES
menu selection to delete all stored data, or
CLEAR ALL DATA
YES
NO
M
UP/DOWN buttons
ENTER
CLEAR ALL DATA
button
YES
NO
M
7
buttons then press
buttons then press
/DOWN
02:
15:40:15
2014/01/26
OR
TQ: 14.2 FT-LBS
M
01 :
15:35:05
2014/01/26
OR
TQ: 15.3 FT-LBS
ANG: 84°
M
button for 3 seconds.
buttons then press ENTER
LANGUAGE
ENTER
SET HEAD LENGTH
button
SHOW DATA
CLEAR DATA
LANGUAGE
ENTER
button
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
M
buttons.
If clock has been
set data
timestamp will
be displayed
(see Advanced
Configuration).
NO
menu
Publicidad
