Descargar Imprimir esta página

Snap-On TECHANGLE STEEL ATECH2FS100 Manual Del Usuario página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

User Instructions
Basic Functions (Quick Start)
BATTERY
PROGRESS
CONDITION
DATA
STORAGE
ALERT
Wrench Power On Sequence
Note: Do not turn on wrench while torque is applied, otherwise torque zero offset will be incorrect
and wrench will indicate a torque reading when torque is released. If this occurs, re-zero
wrench by momentarily pressing POWER
torque applied.
1. Turn On Wrench.
Momentarily press POWER
screen. If previous measurement was angle measurement, then angle re-zeroing screen follows
the torque zeroing screen. After re-zeroing, the target torque or target angle screen is displayed
depending on previous measurement mode.
2. Select Measurement Mode.
Toggle between target TORQUE and ANGLE screens by repeatedly pressing ENTER
TORQUE AND/OR
ANGLE DISPLAY
MODE
LIGHTS
COUNT
PROGRESS
UNITS AND
LIGHTS
PRESET ENTRY
BUTTON
Install three fresh "AA" cells into wrench handle.
button. Snap-on logo is displayed followed by torque re-zeroing
TORQUE ZEROING
250.0
Target Torque Screen
POWER
ANGLE ZERO REQ
button
180°
PROGRESS LIGHTS
Yellow - First light indicates 40% of target torque
Green - Indicates target torque or angle reached.
Red
ON/OFF
AND
RE-ZERO
BUTTON
INCREMENT
BUTTON
DECREMENT
BUTTON
Figure 1
button while wrench is on a stable surface with no
ENTER
00
button
FT-LB
ENTER
button
00
3
or angle reached, Second indicates 60%
of target reached, Third indicates 80% of
target reached.
- Indicates exceeded torque or angle
target+4% for targets above 20% to
100% of F.S. or target+10% for targets
from 5% to 20% of F.S, or exceeded
MAXIMUM Preset target (Note: Yellow
lights also turn on with red).
MODE SELECT, MENU ENTRY AND ENTER BUTTON
AUDIBLE ALERT
LCD BACKLIGHT
AND
PEAK TORQUE/ANGLE
RECALL BUTTON
ANGLE ZEROING
--
SET STILL
00
180°
Target Angle Screen
button.

Publicidad

loading

Este manual también es adecuado para:

Techangle steel atech3fs250Techangle steel atech4rs600