Bobbin Winding - Sears Kenmore 385.17324 Manual De Instrucciones

• Bobbin winding
® For horizontal spool pin
® For additional spool pin
[] Pull the handwheel out to the right.
[] Draw thread from the spool
[] Guide the thread around the thread guide.
[] Thread through the hole in the bobbin from the inside to
the outside,
[] Put the bobbin on the bobbin winder spindle.
[_ Push the bobbin to the dghL
[] With free end of the thread held in your hand, depress the
foot control Stop the machine when it has made a few
turns and cut the thread close to the hole in the bobbin.
[] Depress the foot control again. When the bobbin is fully
wound, it stops automatically. Return the bobbin winder
to its original position by moving the spindle to the left and
cut the thread as shown,
[] Push the handwheet in_The machine will not function until
the clutch is engaged.
• The machine does not function until the clutch is
engaged.
NOTE:
Position of the bobbin winder stopper is adjustable
for the required amount of thread on the bobbin
(example 1/2 full or ful! etc.,)o
Use a screwdriver and loosen the screw one turn
or tess so that you can adjust the position of the
bobbin winder stopper.
Do not take out the screw all the way.
[]
®
................ J
®
[]
[]
[]
[]
.J
22