Bar Tacking; Embroidery - Sears Kenmore 385.17324 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Bar Tacking
Stitch selector:
2
(_) Stitch width:
2 to 6.5
® Stitch length:
0°5 to 1
® Needle thread tension:
2 to 6
(_) Presser foot A:
Zigzag foot
This is similar to a very short satin stitch and is used to rein-
force points of strain such as corners, pockets and straps of
lingerie.
Sew four (4) to six (6) stitches.
Embroidery
Stitch selector:
2
(_) Stitch width:
1 to 6.5
® Stitch length:
Any
(_) Needle thread tension:
2 to 6
(_) Feed dogs:
Dropped
*Pressure foot:
Remove
Drop the feed dogs and remove the foot holder..Adjust stitch
width as desired. Draw a design onto the fabric with tailor's
chalk° Stretch the fabric between embroidery hoops and place
under the needle.
Lower the presser foot lifter to engage the needle thread
tension_ Holding the needle thread in your left hand, rotate the
handwheel counterclockwise
for one complete turn°
Pull the needle thread to draw the bobbin thread to the right
side of the fabric. At medium speed, stitch along the marked
o_ztline, guiding the fabric carefully by hand. After embroidery
is completed, raise the feed dogs for normal sewing°
f
(-
O
_
WIDTH
(_)
®
_LENGTH
(_)
®
%
®
_
WIDTH
_
LENGTH
@
=
®
®
J
fl
52

Publicidad

Tabla de contenido
loading

Tabla de contenido