Publicidad
Idiomas disponibles
Idiomas disponibles
5
4
4
ATTENTION: the following operations must be carried out by qualified personnel. Incorrect operations could
result in machine malfunctions.
14. Disconnect the connector on the machine's electrical system wiring from the connector on the power cable
from the battery box.
15. Grip the handle (2) and turn the upper body (3) to its working position.
16. Secure the machine to the means of transport using an appropriate number and type of fastening elements,
based on its weight and size.
CAUTION: secure the machine according to the directives in force in the country of use, so that it cannot
slide or tip over.
TYPE OF BATTERY TO BE USED
To obtain good work results, the machine must be powered at 24V. HILLYARD recommends using four 6V
210Ah
gel batteries.
C5
The dimensions of the battery-holder compartment are: 215x260x725 mm (length x height x width, according to the
work direction).
N.B.: the function board in the machine is programmed by the factory to work with the following type of
battery: Gel60. To change it, see
"OPERATOR INTERFACE CONFIGURATION MANUAL" consigned together with the machine
documentation.
BATTERY MAINTENANCE AND DISPOSAL
For battery maintenance and recharging, follow the instructions contained in the document provided by the battery
manufacturer.
When the batteries are dead, they must be disconnected by a technician from a HILLYARD service centre; using
suitable lifting devices, remove the batteries from the machine and take them to a specific disposal centre.
N.B.: used batteries, which are classified as hazardous waste, must be returned to a legally authorised
waste disposal authority.
INSERTING THE BATTERIES IN THE MACHINE
To fit the batteries inside the machine, contact an HILLYARD assistance centre technician.
WARNING: HILLYARD declines all responsibility for any damage to property or injury persons in the event
that the batteries are replaced by an unauthorized technician.
6
5
"BATTERY TYPE MENU (GENERAL BATTERY)" on page 17
32
32
7
8
6
in the
-
Publicidad
