Publicidad
Idiomas disponibles
Idiomas disponibles
VACUUM SYSTEM ACTIVATION/DEACTIVATION
If you pass over a wet surface while using the machine, deactivate the vacuum system to avoid damaging the
vacuum filter. Deactivate the vacuum system via the switch (1) on the control panel (Fig.1).
N.B.: when the vacuum system is active, the symbol (2) will appear on the control display (Fig.2).
N.B.: when the vacuum system is not active, the symbol (3) will appear on the control display (Fig.3).
1
ADJUSTING THE FILTER SHAKER MODE
1
N.B.: in automatic mode, the filter shaker is automatically commanded by the function board according to the
three "Shake Frequency" parameters that manage the standby time before the filter shaker begins working
automatically. To change the "Shake Frequency" time, refer to
(VACUUM SHAKE MOTOR)" on page 31
consigned with the machine documentation.
N.B.: when the "Shake Frequency" time expires, the suction motor is automatically switched off and, after
two seconds, the filter shaker motor is activated for just over one second. Once the filter shaker has been
activated, the suction motor starts up again.
N.B.: in manual mode, the suction motor is automatically switched off when the button (1) is pressed and
then, after two seconds, the filter shaker motor is activated for just over one second. Once the filter shaker
has been activated, the suction motor starts up again.
1
2
The filter shaker function can be set in the following ways:
•
manual
•
automatic
N.B.: when the machine is turned on, the "FILTER SHAKER"
function is set by default in automatic mode. To switch to manual
mode, keep the button (1) pressed for more than three seconds
(Fig.1). Do the same if you want to switch from manual to automatic.
in the "OPERATOR INTERFACE CONFIGURATION MANUAL"
51
51
2
2
3
3
2
3
"SHAKE MOTOR FREQUENCY MENU
3
Publicidad
