Publicidad
Idiomas disponibles
Idiomas disponibles
1
3
N.B.: by selecting the ECO MODE working program, the values of the working parameters will be
automatically changed.
MANUAL MODE WORKING PROGRAM
With the MANUAL MODE working program, it is the operator who evaluates and chooses the parameters based on
the cleaning requirements that arise during the course of the work activities.
To switch from ECO MODE or ZONE PROGRAM to MANUAL ZONE:
•
Change the forward speed. See
•
Switch from automatic filter shaker mode to manual mode. See
on page
51.
•
Activate the extra-pressure (central brush) function. See
BRUSH)" on page
52.
PROGRAM ZONE WORKING PROGRAM
2
1
N.B.: If a value for of one of the ZONE programs' performance levels needs to be changed, simply make the
desired change, and then hold down the button for the program to be modified for about three seconds. The
change will be saved when the corresponding LED flashes.
N.B.: by selecting one of the three ZONE programs, the values of the working parameters are automatically
changed.
2
"ADJUSTING THE FORWARD SPEED" on page
"EXTRA PRESSURE FUNCTION (CENTRAL
In order to facilitate the operator's work activities for recurring
interventions at work sites, the decision was made to equip the machine
with three stored working programs, so that the most appropriate
performance levels for each work area are already set.
To select a zone working program, simply press one of the three buttons
(1) at the bottom of the control panel.
N.B.: When the WORK ZONE program is active, the
corresponding LED (2) will be illuminated.
N.B.: to deactivate the WORK ZONE working program, simply:
•
Activate the ECO MODE program. See
CHECKLIST" on page
•
Activate the MANUAL MODE program. See
WORKING PROGRAM" on page
41
41
4
50.
"ADJUSTING THE FILTER SHAKER MODE"
"WORK PREPARATION
39.
41.
"MANUAL MODE
Publicidad
