Publicidad
Idiomas disponibles
Idiomas disponibles
HOUR METER
1
EMPTYING THE DEBRIS HOPPER
If you notice that the machine can no longer collect the dirt from the floor while cleaning, the debris hopper in the
rear part of the machine might be full.
To empty the debris hopper, proceed as follows:
1.
Take the machine to the designated waste disposal area.
N.B.: the place designated for this operation must comply with current regulations concerning safety at work
and current environmental protection regulations.
2.
Bring the front of the machine close to the waste container.
3.
Activate the filter shaker by pressing the "FILTER SHAKER CONTROL" button (1) on the control panel (Fig.1).
ATTENTION: Do not keep the switch (1) pressed longer than ten seconds; repeat this operation two or three
times.
4.
Perform all the operations required to secure the machine. See
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the
work to be carried out.
5.
Turn the latches (2) to release the debris hopper (Fig.2) (turn the left latch anti-clockwise and the right latch
clockwise).
6.
Gripping the handle (3) on the debris hopper (Fig.3), remove it from the machine.
1
1
7.
Take the debris hopper to the appropriate location for unloading and empty it.
The control display is located on the machine control panel. The central part of
1
the screen displays the hour meter on the upper row (1) (Fig.1).
The hour meter (1) allows the user to view the machine's total time of use via a
series of numbers.
N.B.: the digits preceding the (".") identify the hours, while the digits that
come after the "." identify the tenths of an hour, a tenth of an hour
corresponds to six minutes.
2
2
"MACHINE SAFETY" on page
3
49
49
29.
3
Publicidad
