Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING WORK
We will take sweeping mode (with the ECO MODE working program) as an example. To start working, proceed as
follows:
1.
Carry out all the checks listed in the
2.
Sit on the driver's seat.
3.
Insert the key (1) into the slot (2) on the right side of the column (Fig.1).
4.
Turn on the machine and turn the key (1) a quarter turn clockwise (Fig.2).
After ignition, the display will show a series of screens in sequence. Fig.3 shows the screen with the machine
5.
programming characteristics.
N.B.: the type of battery programmed for the battery control board is shown at the top of the screen (3)
(Fig.3). The total hour meter and partial hour meter of the machine are shown at the centre of the screen (4),
on the upper and lower rows respectively (Fig.3). The software version of the function board (SwF) and the
software version of the display (SwD) are shown at the bottom of the screen (5), on the left and right hand sides
respectively (Fig. 3).
2
1
N.B.: the type of battery displayed (3) is the one selected in the list of function board parameters. To change
the type of battery, contact a HILLYARD service centre or refer to
BATTERY)" on page 17
the machine documentation.
N.B.: the hour meter shown in the control display (4) (Fig.3) is the one selected in the list of function board
parameters. To change it, contact a HILLYARD service centre or refer to
(GENERAL HOUR METER)" on page 19
consigned with the machine documentation.
N.B.: the work screen Fig. 4 will appear after the screen containing the machine's programming
characteristics. On the left side of the screen (6), you can see the filter shaker activation frequency. See
"SHAKE MOTOR FREQUENCY MENU (VACUUM SHAKE MOTOR)" on page 31
INTERFACE CONFIGURATION MANUAL" consigned with the machine documentation.
N.B.: in the centre of the screen (7), you can see the battery charge percentage (on the upper line) and the
hour meter (on the lower line). See
on page 19
of the "OPERATOR INTERFACE CONFIGURATION MANUAL" consigned with the machine
documentation.
N.B.: on the right side of the screen (8), you can see the machine movement speed. See
FORWARD SPEED" on page
N.B.: when the machine is turned on, the TRANSFER working mode is enabled.
6.
The machine is now in the transfer working mode.
Press the button (9) on the control panel (Fig. 5) to activate the ECO MODE working program.
7.
"WORK PREPARATION CHECKLIST" on page
1
2
of the "OPERATOR INTERFACE CONFIGURATION MANUAL" consigned with
of the "OPERATOR INTERFACE CONFIGURATION MANUAL"
"PARTIAL HMR O DISPLAY MENU (GENERAL HOUR METER)"
50.
3
4
1
"BATTERY TYPE MENU (GENERAL
"PARTIAL HMR O DISPLAY MENU
45
45
39.
3
5
of the "OPERATOR
"ADJUSTING THE
Publicidad
