Publicidad
Idiomas disponibles
Idiomas disponibles
WORK PREPARATION CHECKLIST
Check for any fluid leaks
Check the horn; the front and rear lights; the safety lights
and the alarm (if installed)
Check the service brakes and steering are functioning
properly
Check the electric brake is correctly engaged
Check the tyres to make sure they are not damaged
Check the charge level of the battery box
Adjust the driver's seat
Check whether the debris hopper (in the rear part of the
machine) is full
Check all the dust guards of the central brush
compartment for signs of damage or wear
Check the central brush is not dirty, damaged or worn.
Check the side brush is not dirty, damaged or worn.
Check the front dust guard kit for signs of damage or
wear
Check the condition of the vacuum filter on the debris
hopper
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you.
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you.
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you.
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you.
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you.
Check the charge level of the battery box on the control
display, and recharge it if necessary. See
THE BATTERIES" on page 33
Before beginning the job, adjust the driver's seat. See
"ADJUSTING THE DRIVING POSITION" on page 35
If the debris hopper is full, empty it. See
DEBRIS HOPPER" on page 49
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you.
If the brush (in the central machine tunnel) is dirty, clean it.
See
"CLEANING THE CENTRAL BRUSH" on page 68
If the brush (in the central machine tunnel) is worn
or damaged, replace it. See
REPLACEMENT" on page 73
If the brush (in the side brush head) is dirty, clean it. See
"CLEANING THE SIDE BRUSHES" on page 69
If the brush (in the side brush head) is worn or damaged,
replace it. See
"ASSEMBLING THE SIDE BRUSHES"
on page 74
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you.
If the collection filter is clogged or dirty, clean it. See
"CLEANING THE PANEL FILTER" on page 69
"CLEANING THE POCKET FILTER (OPTIONAL)"
on page 70
39
39
"RECHARGING
"EMPTYING THE
"CENTRAL BRUSH
or
Publicidad
