De Dietrich DOP350 Serie Instrucciones De Uso página 52

99625044_ML_A.qxd 24/07/03
H
4. ow to use the pyro-clean program
1) Carrying out an immediate pyrolysis cleaning session
a) Remove any accessories from the oven and wipe off any excess
grime.
b) Check that the programmer displays normal time and that it is not
flashing.
c) Press the program selection touch control until the "Pyro-clean"
program appears.
Your oven displays the pyro-clean symbols
You can select the another cycle (
oven together with "Pyr" which
corresponds to the 2h Pyro cycle.
With this cycle the oven cannot be used for 2h 30. This time allows for cooling
down until the door automatically unlocks itself.
d) Press the START/STOP touch control.
For Pyro Control the
The door is locked automatically during pyro-cleaning (after a few minutes).
You can consult the finishing time for the pyro-clean cycle by pressing touch
(Only for the Pyro 2h cycle).
control
After pyro-cleaning the
e) Stop the oven by pressing the START/STOP touch control.
52
16:56 Page 52
START
STOP
START
STOP
2h) non-changeable, by pressing the + touch control.
The
START
STOP
symbol moves.
For Pyro 2h the
symbol remains lit until the door is automatically unlocked.
Model DOP360
ECO
and Ctl corresponding to "Pyro Control".
ECO
symbol will then be displayed on your
ECO
symbol remains steady.