Janome 385.4052LX200 Manual De Instrucciones página 2

Tabla de contenido

Publicidad

iMPORTANT
SAFETY INSTRUCTPONS
CAUTION
Your sewing machine is designed
and constructed
only for HOUSEHOLD
use
Before using this sewing machine,
read this manual and follow all Safety Rules and Operating
Instructions
DA NG ER- To reduce
the r isk o f e lectric
shock:
1
This sewing machine should never be left unattended
when plugged in Always unptug this sewing machine
from the
electric outlet immediately
after using and before cleaning.
2. Always unplug before replacing
a sewing machine
butb Replace bulb with same type rated !5 Watts
3
Do not reach for a sewing machine that has fallen into water Unpiug immediately
4, Do not place or store this sewing machine where it can fall or be pulled into a tub or sink Do not place or drop it into water
or other liquid,
WARNING-
To ,educe
the r isk o fburns,
fire, e,ectric
shock,
or injury to persons:
1, Do not allow this sewing machine
to be used as a toy Close attention is necessary when this sewing machine is used by
or near children
2
Use this sewing machine only for its intended use as described
in this owner's manual
Use only attachments
recommended
by the manufacturer
as contained
in this owner's manual,
3
Never operate this sewing machine
if it has a damaged
cord or plug, if it is not working properly, if it has been dropped
or damaged,
or dropped into water
Return this sewing machine to the nearest Sears store or service center for examination,
repair, electrical or mechanical
adjustment,
4. Never operate this sewing machine with any air opening blocked, Keep ventilation
openings
of this sewing machine and
foot controller free from accumulation
of lint, dust and loose cloth
5
Never drop or insert any object into any opening
6
Do not use outdoors..
7, Do not operate where aerosol (spray) products are being used or where oxygen is being administered
8
To disconnect,
turn all controls to the off (" O")
position, then remove plug from outlet
9
Do not unplug by pulling on cord To unplug, grasp the plug, not the cord,
t0 Keep fingers away from all moving parts. Special care is required around the sewing machine
needle
11 Always use the proper needle plate.. The wrong plate can cause the needle to break
12,,Do not use bent needles
I3 Do not pull or push fabric while stitching.. It may deflect the needle causing it to break,,
14 Switch this sewing machine
off ("O")
when making any adjustment
in the needIe area, such as threading
the needle,
changing
the needle, threading
the bobbin or changing
the presser foot, and the tike
!5, Always unplug this sewing machine from the electrical
outlet when removing covers, lubricating,
or when making any
other adjustments
mentioned in this owner's manual
SAVE THESE
INSTRUCTIONS
When using your sewing machine
for the first few times, place a waste fabric under the presser foot and run
/
the machine without thread for a few minutes
Wipe away any oil which may appear
J

Publicidad

Tabla de contenido
loading

Tabla de contenido