Setting Starting Points; During Operation; Automatic Mowing - Stihl RMI 422 P Manual De Instrucciones

Ocultar thumbs Ver también para RMI 422 P:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Reset settings
► Press the OK button and enter the PIN code.
The robotic mower will be reset to factory defaults and the
installation assistant will be started, @ 10.

15.6 Setting Starting Points

► Set starting points to target automatic mowing in a specific
part of your lawn. Starting points are used to access linked
areas that are only accessible via a corridor. Starting
points are used when parts of your lawn are not being
mowed frequently enough, sometimes because part of the
mowing area is accessible only through a corridor.
Starting points can be set in two different ways.
"Teaching-in" starting points
Press the OK button. The robotic mower will begin to
travel along the perimeter wire. If it is not docked, it
first travels to the docking station. All current existing
starting points are deleted.
To teach-in up to 4 starting points:
► Save each starting point by pressing the OK button during
the robotic mower's travel.
► The teach-in procedure is interrupted automatically when
the robotic mower contacts obstacles along the perimeter
wire. If the teach-in procedure is interrupted automatically,
correct the position of the perimeter wire and remove any
obstacles along the cutting path or correct the installation
of the perimeter wire.
► If necessary, interrupt the teach-in procedure manually by
pressing the STOP button.
► Check the position of the robotic mower before continuing
the teach-in procedure. The robotic mower must either be
located on the perimeter wire or within the mowing area
facing the perimeter wire.
► The starting frequency defines how often a mowing
operation is to begin from a starting point. The default
setting is 2 of 10 mowing operations (2/10) at each starting
point. You can change the starting frequency as desired
after each teach-in.
56
► If the teach-in procedure has been ended prematurely,
send the robotic mower back the to docking station.
Setting starting points 1 to 4 manually:
Press the OK button. All current existing starting
points are deleted.
To manually set up to 4 starting points:
► Determine the distance of the starting points from the
docking station. The distance corresponds to that covered
from the docking station to the starting point in meters,
measured in a clockwise direction.
► Set a starting frequency between 0 of 10 mowing
operations (0/10) and 10 of 10 mowing operations (10/10).
The docking station is defined as starting point 0. Mowing
operations are started from the docking station as a
default.

16 During Operation

16.1 Automatic Mowing

WARNING
Keep bystanders away from the mowing area during active
times. Never allow children to approach or play with the
robotic mower. Keep children out of the mowing area while
the mower is in operation. Never allow the robotic mower to
operate if you know that animals or persons are or may be
in the mowing area or vicinity.
16 During Operation
0478-131-3045-A

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido