John Bean B 600 Manual Del Operador página 128

128
User Code
Code C4
Compensation of residual unbalance, if any, in the
clamping device
High precision measurement (this mode cannot be
transferred into the permanent memory).
Every time the clamping device is replaced,
compensation must be deleted or carried out again
with the new device fi tted.
Resetting the operating status to 0 cancels the
clamping device compensation.
Compensation is cancelled also after machine
calibration or recalibration, an unbalance optimisation,
or if the machine is switched off
Code C5
Stop of the wheel when the wheel guard is lifted
during the measuring run
0 = Stop deactivated
THE WHEEL ROTATES WHEN THE WHEEL GUARD
IS OPEN.
MAKE SURE THAT THE WHEEL IS NOT BLOCKED
BY A TOOL OR SIMILAR ITEM.
WEAR SAFETY GOGGLES AND TIGHTLY FITTING
WORKING CLOTHES.
1* = Stop activated
After the confi rmation OK, this operating mode can be
acquired in the permanent memory (C10).
Code C6
Number of revolutions per measuring run - 5 to 25
revolutions possible, factory–set to 10*
Warning
Reducing the number of measurement revolutions will
reduce the accuracy of measurement.
After the confi rmation OK, this operating mode can be
acquired in the permanent memory (C10).
Code C7
Allows disabling key sound.
0 = Sound disabled
1 = Sound enabled
* = Factory-adjusted mode
F
6.1.