Status At Switching On - John Bean B 600 Manual Del Operador

6b
7b
48
5-11
Operation

5.4.2 Status at switching on

The electronic unit is factory-adjusted to the following The electronics is factory programmed so that upon
modes of operation, which are available after switching
machine start-up the following operating modes are
on:
pre-set:
– vehicle type 1 (car wheel with nominal dimensions in – vehicle type 1 (car wheel with nominal
inches, width 6.5" and diameter 15.0"). dimensions in inches, width 6.5" and diameter
15.0")
– entry of rim data in inches.
– entry of rim data in inches
– display of amount of unbalance in 0,25 oz increments.
– display of amount of unbalance in 5 g increments
– suppression of minor unbalance readings (limit set
– suppression of minor unbalances (limit set to:
to 0,25 oz).
3.5 g)
– automatic braking of wheel when guard is opened
– automatic braking of wheel when guard is
during the measuring run.
opened during the measuring run
– compensation of adaptor unbalance switched off.
– compensation of adaptor unbalance switched
– Starting the mesuring run by closing the wheel guard.
off
– Starting the measuring run by closing the wheel
guard.
5.4.3 Direct Settings
Upon switching on, the unit shows the default unit of
measurement in inches.
5.4.3.1 Dimension Unit Toggle
Default diameter and width unit setting: inches.
• Press the "mm" or "inch" icon (6b, Fig.5-11).
The measuring unit changes to the possible alternative.
5.4.3.2 Weight Unit Toggle
Default weight setting:
Select before or after performing a run, indifferently.
• Press the "g" or "oz" icon (7b, Fig.5-11).
The measuring unit changes to the possible alternative.
ounces grams.