John Bean B 600 Manual Del Operador página 96

26
26
96
5-69
26
5-70
5-71
5-72
5-73
Operation
Figure 5-69 MINIMISATION "Un.6"
— Rotate the wheel into marking position following the
arrows.
— In this position mark the tyre, on the outer side of
the wheel, precisely above the chuck.
— Confi rm by pressing the key 26.
The MINIMISATION "Un.7" screen is displayed (Fig.
5-56).
Figure 5-70 MINIMISATION "Un.7"
— On the tyre changer, turn the tyre with respect to
the rim until the valve is aligned with the mark made
on the tyre.
— Confi rm by pressing the key 26.
The MINIMISATION "Un.8" screen is displayed
5-71).
Figure 5-71 MINIMISATION "Un.8"
— Clamp the wheel.
— Rotate the wheel until the valve is exactly
perpendicular to and above the chuck.
— Confi rm the valve position by pressing the key 26.
The MINIMISATION "Un.9" is displayed (Fig. 5-72).
Figure 5-72 MINIMISATION "Un.9"
START is displayed on the screen
— Perform the wheel measuring run.
A measuring run is performed.
The MINIMISATION screen "Un.10" is displayed,
outside (Fig. 5-73) or the MINIMISATION "Un.10"
appears, inside (Fig. 5-75).
With indication H0
Optimum condition has been achieved and cannot be
improved.
— Continue as shown on screen BALANCING (Fig.
5-62).
(
Fig.