Installation Procedure - John Bean B 600 Manual Del Operador

1
2
5
8
6
146
iii-1
iii-2
3
4
iii-3
7
iii-3a
Installation
iii Installation procedure
Unit:
Refer to the drawing in i section for correct
wheel balancer positioning. If the wheel balancer
needs securing, we recommend fi xing elements
with a diameter of 8 mm, quality 8.8 or higher.
Supports for Accessories:
• Unpack the 4 threaded accessory support studs
and the support plates.
• Refer to Figure iii-1. Fit the 4 threaded accessory
support studs and the plates.
Threaded shaft:
• Clean the threaded shaft and the hole in the main
shaft.
• Refer to Figure iii-2. Position the threaded shaft.
• Use a pin for screwing.
Clamping devices:
• Put the clamping devices on the accessory support
pins and in the appropriate housings.
Wheel guard:
• Refer to Figure iii-3.
The wheel guard infl uences the following operating
modes:
— The measuring run is started by closing the wheel
guard (Code C13).
— The wheel is braked by lifting the wheel guard
during a measuring run (code C5).
Fig. iii-3
— Slide the wheel guard (1) on the support shaft (2)
and rotate the tube of the wheel guard until the
wheel guard fastening holes match with the support
shaft holes.
— Insert the M10 fastening screw (3) with washer (4)
from below, and tighten the hexagon nut (5) and
washer fully home.
Figure iii-3a
— Connect the plug of the cable (6) with the connector
of the machine (7) which is projecting out of the
opening of the machine cabinet.
— Place the plug cable loosely inside the machine
through the hole in the machine cabinet.
Warning:
Since the cable is moved during the wheel guard
opening and closing, it must be routed through
retainer (8, Fig. iii-3a) under the guard support.