Maintenance Intervals; Changing The Cutter - Abicor Binzel DAV Guia De Instalacion

9 Maintenance and cleaning

9.1 Maintenance intervals

Weekly
Check the cutter and replace if necessary

9.1.1 Changing the cutter

1 Cover
2 Counter support with pressure spring
Fig. 8 Changing the cutter
EN - 16
NOTE
• Maintenance and cleaning work must only be carried out by qualified
personnel (in Germany see TRBS 1203).
• Always wear your personal protective equipment when performing
maintenance and cleaning work.
NOTE
• The specified maintenance intervals are guidance values and refer to
single-shift operation.
Check the following:
The service life of the cutter depends on the filler wire to be cut.
NOTE
• Worn-out cutting edges may cause malfunctions. A cost- and time-saving
remedy is to correct the start-up position by a few millimetres. Only when
the entire cutting width of the cutter has been worn out, will a
replacement be required.
3 Jaws
4 Housing
Monthly
Lubricate the device
1 2
6 5
5 Cutter
6 Slide
DAV
3
4