Maintenance Intervals - Abicor Binzel 241 Instructivo De Servicio

MIG/MAG ROBO welding torch

9.1 Maintenance intervals

9.2 Liner
1
1 Torch head
2 Central connector
Fig. 3 Shortening the spiral liner
NOTICE
• The specified maintenance intervals are standard values and refer to
single-shift operation.
Observe the provisions of EN 60974-4 Inspection and testing during the
operation of arc welding equipment plus any national laws and regulations.
• We recommend basic cleaning once a week. The type and frequency of
cleaning shall be determined and established by the system operator of
the welding system.
• Clean weld spatter from the torch head daily. In the case of heavy weld
spatter build-up, clean during each welding break.
NOTICE
• New and unused liners must be shortened to the actual length of the
cable assembly.
3 Nut
1 Disassemble the equipment parts from the torch head (1).
2 Loosen the nut (3) from the central connector (2).
3 Lay out the cable assembly in a stretched position.
4 Push the liner through the wire conduit until the retaining nipple (4).
5 Hand-tighten the nut (3).
6 Cut off any excess length (x) flush with the torch head and pull out the liner
again.
9 Maintenance and cleaning
2
4
4 Retaining nipple
EN - 17
3