Warming Up The Engine - TOHATSU MFS 6BZ Manual Del Propietário

7. Set the control lever in the Neutral
position.
8. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it quickly.
9. After engine starts, do not reinstall fly-
wheel cover and top cowl.
ENOM00518-0
If the choke solenoid fails to
operate (EP and EPT type only)
1. Remove the top cowl.
2. Close the choke plate by finger.
3. Raise the Free accel lever a little.
4. Turn the main switch key to start posi-
tion.
5. Stop pushing the key when the engine
has started.
6. Return the choke plate to open posi-
tion.
1. Choke plate (open position)
1. Choke plate (closed position)
ENOM00043-A

3. Warming up the engine

ENOW00932-0
Be sure to check that cooling water is
coming out of the cooling water check port
during warm up.
Warm the engine at low engine speeds for
about
3 minutes : above 5°C (41°F)
5 minutes at 2000 min
(41°F)
This allows the lubricating oil to circulate to
all parts of the engine. Operating the
1
engine without warm up shortens the
engine's life.
ENOF00528-0
ENGINE OPERATION
1
ENOF00529-0
CAUTION
-1
(rpm) : blow 5°C
ENOF01411-1
41
7