Stryker Power-PRO IT Manual De Uso Y Mantenimiento página 48

LOADING THE COT INTO A VEHICLE WITH TWO OPERATORS - MANUAL METHOD (CONTINUED)
English
6. Operator 2 − Verify that the safety bar engages the
safety hook.
7. Operator 1 − Grasp the cot frame at the foot end. Lift
the foot end of the cot until the weight is off of the cot
base. Squeeze and hold the release handle as shown
in Figure 25.
8. Operator 2 − Stabilize the cot by placing your hand on
the outer rail. Grasp the base frame. After the foot end
operator has lifted the cot and squeezed the release
handle, raise the undercarriage until it stops in the
highest position and hold it there.
9. Both Operators − Push the cot into the patient
compartment, engaging the cot fastener (not included).
Note: When operating the manual back-up release handle,
avoid rapid lifting or lowering of the base or movement may
appear sluggish; lift with a slow constant motion.
Return To Table of Contents
1-42
Operation Guide
Figure 25: Manual Back-up Release Handle
6516-109-005 REV B www.stryker.com