Unloading An Empty Cot From A Vehicle With One Operator - Manual Method - Stryker Power-PRO IT Manual De Uso Y Mantenimiento

UNLOADING AN EMPTY COT FROM A VEHICLE WITH ONE OPERATOR - MANUAL METHOD

Unloading an unoccupied cot from a vehicle can be accomplished by a single operator.
WARNING
• The one person loading and unloading procedures are for use only with an empty cot. Do not use the procedures
when loading or unloading a patient. Injury to the patient or operator could result.
• Do not pull or lift on the safety bar when unloading the cot. Damage to the safety bar could result and injury to the
patient or operator could occur.
• Ensure proper hand placement on hand grips. Hands should be clear of red safety bar pivots while loading and
unloading the cot or whenever changing height position of the cot with two or more operators.
To unload an empty cot from a vehicle with one operator:
1. Lift the vehicle bumper to the raised position (if equipped).
2. Disengage the cot from the cot fastener. (For more information about the cot fastener, see
3. Grasp the cot frame at the foot end.
4. Pull the cot from the vehicle until the safety bar engages the safety hook.
5. Pull the manual back-up release handle to lower the undercarriage to its fully extended position.
6. Disengage the safety bar from the safety hook by pulling the safety bar release lever forward and roll the cot out
of the vehicle.
7. Remove the load wheels from the patient compartment of the vehicle.
CAUTION
When unloading the cot from the patient compartment, ensure that the caster wheels are safely set on the ground or
damage to the product may occur.
www.stryker.com
Operation Guide
6516-109-005 REV B
page 1-21).
Return To Table of Contents
1-45
English