Loading Or Unloading The Cot; Loading Or Unloading The Cot With The Power-Load Option; High Speed Retract/Extend - Stryker Power-PRO IT Manual De Uso Y Mantenimiento

LOADING OR UNLOADING THE COT

The cot loading and unloading instructions on
use with Power-LOAD. For Model 6516 cots with the Power-LOAD option, see the Power-LOAD Operations/Maintenance
Manual for loading and unloading instructions.

LOADING OR UNLOADING THE COT WITH THE POWER-LOAD OPTION

The Model 6516 Power-PRO™ IT cot is fully compatible with the Model 6390 Power-LOAD system if it is ordered with
the Power-LOAD option or compatibility kit (6516-700-001).
For more information about using your Power-LOAD compatible cot, see the Power-LOAD Operations/Maintenance
Manual.
WARNING
• Power-LOAD is designed to be compatible with the 6085/6086 Performance-PRO XT, 6500/6516 Power-PRO XT,
and 6510/6516 Power-PRO™ IT cots with the Power-LOAD option only. In certain situations, you can use
Power-LOAD as a standard antler for most X-frame cots, but a rail clamp assembly is required for all cots without
the Power-LOAD option.
• It is the responsibility of the cot operator to ensure that the cot being used in the Stryker Model 6390 Power-LOAD
system is a Power-LOAD compatible cot. Injury may result if a non-compatible cot is used in the Stryker Model 6390
Power-LOAD system.

HIGH SPEED RETRACT/EXTEND

The cot is equipped with a high-speed retract mode to expedite loading/unloading the cot into and out of a vehicle.
• The undercarriage rapidly retracts toward the highest position once the weight of the cot and patient is no longer
supported by the wheels. Press the retract (–) button to actuate the control switch.
• The undercarriage rapidly extends toward the lowest position once the weight of the cot and patient is no longer
supported by the wheels. Press the extend (+) button to actuate the control switch.
WARNING
• Whenever the weight of the cot and patient is no longer supported by the wheels, the cot will automatically enter
the high speed retract mode if the retract (–) button is pressed.
• After the weight is off of the ground, the operators must support the load of the patient, cot and any accessories.
Failure to support the load properly may cause injury to the patient or operator.
www.stryker.com
Operation Guide
page 1-33 through page 1-46
6516-109-005 REV B
are intended for cots that you will NOT
Return To Table of Contents
English
1-33