Removing And Replacing A Smrt™ Pak - Stryker Power-PRO IT Manual De Uso Y Mantenimiento

REMOVING AND REPLACING A
The cot is supplied with two removable 24V SMRT™ Paks as the power source.
See the SMRT™ Power System Operations/Maintenance Manual for additional SMRT™ Pak and SMRT™ Charger
information.
WARNING
• To avoid risk of electric shock, never attempt to open the battery pack for any reason. If the battery pack case
is cracked or damaged, do not insert it into the charger. Return damaged battery packs to a service center for
recycling.
• Do not remove the battery when the cot is activated.
• Avoid direct contact with a wet battery or battery enclosure. Contact may cause injury to the patient or operator.
To remove the SMRT™ Pak:
1. Press the red one hand release button (C) or press the battery release button (A) to release the SMRT™ Pak (B)
from the cot as shown in Figure 27.
2. Slide the released SMRT™ Pak out of the enclosure.
A
To reinstall or replace the SMRT™ Pak:
1. Align the tabs in the battery enclosure.
2. Push the SMRT™ Pak into the enclosure until the latch clicks into place.
• The cot power indicator LED is solid green if the SMRT™ Pak is charged and ready.
• The cot power indicator LED flashes amber if the SMRT™ Pak needs to be recharged or replaced.
Note: Batteries slowly lose power when not on the charger.
CAUTION
Remove the battery if the cot is not going to be used for an extended period of time (more than 24 hours).
www.stryker.com
Operation Guide
PAK
SMRT™
Figure 27: SMRT™ Pak Removal and Replacement
6516-109-005 REV B
B
C
Return To Table of Contents
1-47
English