Installing The Air Sled With A Sled Receptacle - Stryker Power-PRO IT Manual De Uso Y Mantenimiento

INSTALLING THE AIR SLED WITH A SLED RECEPTACLE

English
Prior to installing the Air Sled on the model 6516 Power-PRO™ IT cot, read and understand this manual and the manual
supplied with the incubator. These instructions explain how to install the Air Sled with the manufacturer's supplied sled
receptacle (not included).
WARNING
• The Air Sled, no adaptor option (6516-142-000) is designed to secure incubators without an adaptor to the
model 6516 Power-PRO™ IT cot. Using this configuration on any cot other than the model 6516 Power-PRO™ IT
cot or using any unapproved incubators in this configuration may result in damage to the cot and/or injury to the
patient or user.
• Stryker is not responsible for specification or option changes to Air Sled compatible incubators.
To install the incubator:
1. Use the supplied fasteners to bolt the receptacle to the litter frame as shown in Figure 42.
2. Insert the Air Sled (A) into the receptacle (B) by using the latching system that is included as part of the Air Sled
apparatus.
Return To Table of Contents
1-56
Cot Operation
B
Figure 42: Air Sled Installation
6516-109-005 REV B
A
www.stryker.com