Securing The Air Sled - Stryker Power-PRO IT Manual De Uso Y Mantenimiento

SECURING THE AIR SLED

Prior to installing the Air Sled on the on the model 6516 Power-PRO™ IT cot, read and understand this manual and the
manual supplied with the incubator. These instructions explain how to secure the Air Sled to the litter surface of the
model 6516 Power-PRO™ IT cot with straps.
WARNING
• The Air Sled, no adaptor option (6516-142-000) is designed to secure incubators without an adaptor to the
model 6516 Power-PRO™ IT cot. Using this configuration on any cot other than the model 6516 Power-PRO™ IT
cot or using any unapproved incubators in this configuration may result in damage to the cot and/or injury to the
patient or user.
• Stryker is not responsible for specification or option changes to Air Sled compatible incubators.
To secure the Air Sled to the litter surface:
1. Attach the straps (not supplied), as
shown in Figure 43, to secure the
Air Sled to the litter surface (A).
2. Ensure that the straps (B) are secured
from the litter and not the push bars to
the Air Sled (Figure 43).
3. Confirm that the Air Sled is secured
to the cot as shown in Figure 44.
Figure 44
www.stryker.com
Cot Operation
A
B
6516-109-005 REV B
Figure 43
Return To Table of Contents
English
1-57