Explanation Of Multifunctional Power Interface - Fronius Symo Advanced 10.0-3 208-240 Manual De Instrucciones

Item
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Explanation of Different switching variants can be connected to the multifunctional power interface. These
Multifunctional variants cannot be operated at the same time, however. For example, if an S0 counter is
Power Interface connected to the multifunctional power interface, a signal contact for surge protection can-
not be connected, and vice versa.
16
Description
Switchable multifunctional power interface.
For a more detailed explanation, see the section entitled "Explanation of Multi-
functional Power Interface" which follows
Use the 2-pin mating connector supplied with the inverter to connect to the multi-
functional power interface.
Fronius Solar Net/interface protocol IN connection
Fronius Solar Net/interface protocol OUT connection
Fronius Solar Net/interface protocol input and output for connecting to other DAT-
COM components (e.g., inverter, Fronius Sensor Box, etc.)
When linking several DATCOM components, a termination plug must be placed
on each free IN and/or OUT connection of a DATCOM component.
Two termination plugs are supplied with inverters with Fronius Datamanager
plug-in card.
'Fronius Solar Net' LED
indicates whether a power supply is available for Fronius Solar Net
'Data transfer' LED
flashes when accessing the USB thumb drive. The USB thumb drive must not be
removed during this time.
USB A socket
for connecting a USB flash drive with a maximum size of
65 x 30 mm (2.6 x 2.1 in.)
The USB thumb drive can act as a data logger for an inverter. The USB thumb
drive is not part of the scope of supply for the inverter.
Floating switch contact (relay) with mating connector
max. 250 V AC / 4 A AC
max. 30 V DC / 1 A DC
max. 1.5 mm² (AWG 16) cable cross section
Pin 1 = NO contact (Normally Open)
Pin 2 = root (Common)
Pin 3 = NC contact (Normally Closed)
For a more detailed explanation, see the "Menu items in the setup menu/relay"
section.
Use the mating connector supplied with the inverter to connect to the floating
switch contact.
Fronius Datamanager with WLAN antenna
or
cover for option card slot
Cover for option card slot