Starting For The First Time - Fronius Symo Advanced 10.0-3 208-240 Manual De Instrucciones

Starting for the
NOTE!
First Time
The Fronius Solar.
web app makes starting Fronius Datamanager 2.0 for the first time significantly easier.
The Fronius Solar.web app is available in the relevant app store.
To start Fronius Datamanager 2.0 for the first time,
-
-
IMPORTANT! "Obtain an IP address automatically (DHCP)" must be activated for the end
device in question (e.g., laptop, tablet, etc.) to establish a connection to the Fronius Data-
manager 2.0.
NOTE!
If the photovoltaic system only has one inverter, the following work steps 1 and 2
can be skipped.
Start the process with work step 3 in this case.
1
2
3
The inverter establishes the WLAN Access Point. The WLAN Access Point stays open for
one hour. The IP switch on the Fronius Datamanager 2.0 can remain in switch position B
by activating the WLAN Access Point.
the Fronius Datamanager 2.0 plug-in card must be installed in the inverter,
or
there must be a Fronius Datamanager Box 2.0 in the Fronius Solar Net ring.
Connect the inverters with Fronius Datamanager 2.0 or Fronius Datamanager Box 2.0
in Fronius Solar Net
When linking several inverters in Fronius Solar Net:
Set the Fronius Solar Net master/slave switch on the Fronius Datamanager 2.0 plug-
in card correctly
- One inverter with Fronius Datamanager 2.0 = master
- All other inverters with Fronius Datamanager 2.0 = slave (the LEDs on the Fronius
Datamanager 2.0 plug-in cards are off)
Switch the inverters to service mode
- Activate the WLAN Access Point via the inverter's setup menu
S t a n d b y
W i F i A c c e s s P o i n t
D A T C O M
U S B
C l o c k
23