Safety Rules; General; Environmental Conditions; Qualified Service Engineers - Fronius Symo Advanced 10.0-3 208-240 Manual De Instrucciones

Safety rules

General

The device has been manufactured using state-of-the-art technology and according to rec-
ognized safety standards. If used incorrectly or misused, however, it can cause
-
-
All persons involved in start-up operation, maintenance and servicing of the device must
-
-
-
The Operating Instructions must always be kept to hand wherever the device is being
used. In addition to the Operating Instructions, all applicable local rules and regulations re-
garding accident prevention and environmental protection must also be followed.
All safety and danger notices on the device
-
-
-
-
The terminals can reach high temperatures.
Only operate the device when all protection devices are fully functional. If the protection
devices are not fully functional, there is a risk of
-
-
Any safety devices that are not functioning properly must be repaired by an authorized spe-
cialist before the device is switched on.
Never bypass or disable protection devices.
For the location of the safety and danger notices on the device, refer to the section headed
"General" in the Operating Instructions for the device.
Any equipment malfunctions which might impair safety must be remedied immediately be-
fore the device is turned on.
Your personal safety is at stake!
Environmental Operation or storage of the device outside the prescribed area will be deemed as "not in
Conditions accordance with the intended purpose." The manufacturer is not responsible for any dam-
ages resulting from unintended use.
Qualified Service The servicing information contained in these operating instructions is intended only for the
Engineers use of qualified service engineers. An electric shock can be fatal. Do not carry out any ac-
tions other than those described in the documentation. This also applies to qualified per-
sonnel.
All cables and leads must be secured, undamaged, insulated, and adequately dimen-
sioned. Loose connections, scorched, damaged, or under-dimensioned cables and leads
must be repaired immediately by an authorized specialist.
serious or fatal injury to the operator or a third party,
and damage to the device and other material assets belonging to the operating com-
pany.
be suitably qualified,
have knowledge of and experience in dealing with electrical installations and
have fully read and precisely followed these Operating Instructions.
must be kept in a legible state
must not be damaged/marked
must not be removed
must not be covered, pasted, or painted over.
serious or fatal injury to the operator or a third party,
and damage to the device and other material assets belonging to the operating com-
pany.
7