Relay (Floating Switch Contact) - Fronius Symo Advanced 10.0-3 208-240 Manual De Instrucciones

Logging Interval
Activating/deactivating the USB logging function, as well as setting the logging interval
Unit
Setting range
Factory setting
30 Min.
20 Min.
15 Min.
10 Min.
5 Min.
No Log
IMPORTANT! The time must be set correctly in order for the USB logging function to work
properly. The time setting is handled in the 'Setup menu items' - 'Time/Date' point.
Relay (Floating A floating switch contact (relay) on the inverter can be used to display status codes, the
Switch Contact) inverter status (e.g. the grid power feed operation) or the Energy Manager functions.
Setting range
* is only shown if the "E-Manager" function has been activated under "Relay Mode."
Relay Mode
The following functions can be displayed via the relay mode:
-
-
-
Setting range
Factory setting
Minutes
30 Min. / 20 Min. / 15 Min. / 10 Min. / 5 Min. / No Log
30 Min.
The logging interval is 30 minutes; new logging data is saved to
the USB thumb drive every 30 minutes.
The logging interval is 5 minutes; new logging data is saved to
the USB thumb drive every 5 minutes.
No data is saved
Relay Mode / Relay Test / Switch-on Point* / Switch-off Point*
Alarm function (Permanent / ALL)
Active output (ON / OFF)
Energy Manager (E-Manager)
ALL / Permanent / OFF / ON / E-manager
ALL
Alarm function:
ALL: Switches the floating switch contact for continual and temporary ser-
vice codes (e.g. brief interruption of grid power feed operation, a ser-
vice code occurs a certain number of times per day – can be set in the
"BASIC" menu)
37