Risk Of Electric Shock; Meanings Of Signal Words - Stanley Bostitch MRC2 Manual De Instrucciones

READ THE INSTRUCTION HANDBOOK:
GB
Before positioning, operating or adjusting the compressor, read the instruction book carefully.

RISK OF ELECTRIC SHOCK:

Caution: before doing any work on the compressor, it must be disconnected from the power supply.
RISK OF HIGH TEMPARATURES:
Caution: the compressor contains some parts which might reach high temparatures.
RISK OF ACCIDENTAL START-UP:
Attention: the compressor could start automatically in case of a black-out and subsequent reset.
IMPORTANT INFORMATION
Read and understand all of the operating instructions, safety precautions and warnings in the
Instruction Manual before operating or maintaining this compressor. Most accidents that result from
compressor operation and maintenance are caused by the failure to observe basic safety rules or
precautions. An accident can often be avoided by recognizing a potentially hazardous situation before
it occurs, and by observing appropriate safety procedures. Basic safety precautions are outlined in the
"SAFETY" section of this Instruction Manual and in the sections which contain the operation and
maintenance instructions. Hazards that must be avoided to prevent bodily injury or machine damage
are identified by WARNINGS on the compressor and in this Instruction Manual. Never use this
compressor in a manner that has not been specifically recommended by manufacturer, unless you first
confirm that the planned use will be safe for you and others.

MEANINGS OF SIGNAL WORDS

WARNING: indicates a potentially hazardous situations which, if ignored, could result in serious
personal injury.
CAUTION: indicates a hazardous situations which, if ignored, could result moderate personal injury, or
could cause machine damage.
NOTE: emphasizes essential information
SAFETY
IMPORTANT SAFETY INSTRUCTIONS FOR USE OF THE COMPRESSOR.
WARNING: DEATH OR SERIOUS BODILY INJURY COULD RESULT FROM IMPROPER OR UNSAFE
USE OF COMPRESSOR. TO AVOID THESE RISKS, FOLLOW THESE BASIC SAFETY
INSTRUCTIONS.
READ ALL INSTRUCTIONS
1. NEVER TOUCH MOVING PARTS Never place your hands, fingers or other body parts near the
compressor's moving parts.
2. NEVER OPERATE WITHOUT ALL GUARDS IN PLACE Never operate this compressor without all
guards or safety features in place and in proper working order. If maintenance or servicing requires the
removal of a guard or safety features, be sure to replace the guards or safety feature before resuming
operation of the compressor.
3. ALWAYS WEAR EYE PROTECTION Always wear safety goggles or equivalent eye protection.
Compress ed air must never be aimed at anyone or any part of the body.
4. PROTECT YOURSELF AGAINST ELECTRIC SHOCK Prevent body contact with grounded surfaces
such as pipes, radiators, ranges and refrigeration enclosures. Never operate the compressor in damp
or wet locations.
5. DISCONNECT THE COMPRESSOR Always disconnect the compressor from the power source and
remove the compressed air from the air tank before servicing, inspecting, maintaining, cleaning,
replacing or checking any parts.
6. AVOID UNINTENTIONAL STARTING Do not carry the compressor while it is connected to its power
source or when the air tank is filled with compressed air. Be sure the knob of the pressure switch in the
"OFF" position before connecting the compressor to its power source.