Ottobock 476E52 Instrucciones De Uso página 32

c) Place the top clamp half (Fig. 9) in the desired position on the armrest.
The release knobs for swivel and angle adjustment point outwards.
Attach the Swivel Unit with the lower clamp and the four cap screws
(Fig. 10).
Make sure that the Swivel Unit is mounted in horizontal position. Additionally
tighten the lower clamp with the two set screws to prevent rotation. If there
are holes in the wheelchair's side panel tube, you can also use a screw
M5 x L (not included in the delivery; see table below for the length L) to
prevent rotation (Fig. 10). Make sure that the tightened screw does not
protrude from the upper clamp.
Clamp diameter
⌀ 19 mm (¾")
⌀ 20 mm
⌀ 22.2 mm ( /
7
8
⌀ 25.4 mm (1")
32 | Ottobock
Screw dimensions
M5 x 30
(ISO7380, quality 8.8)
M5 x 30
(ISO7380, quality 8.8)
") M5 x 35
(ISO7380, quality 8.8)
M5 x 35
(ISO7380, quality 8.8)
9 10
Article number
501S89=M5x30
501S89=M5x30
501S89=M5x35
501S89=M5x35