Command And Control Units - CEA DIGISTAR 250 DUAL PULSED Manual De Instrucciones

ALUMINIUM ROLL KIT ASSEMBLY (fig. F)
Insert the idle roller and spacer supplied in the kit into the gear
housing (see figure to right) and secure the assembly to the arm
with the lock pin (1). Remove the lock screw (position 3) and
replace the 2 rollers with the ones supplied in the kit.
1

Command and control units

1
2
3
Pos. 1 Fast coupling straight polarity
Pos. 2 Weld auxiliary control connector
Pos. 3 Fast coupling reverse polarity
Pos. 4 Centralized torch connection
FIG. F
4
6
Pos. 5 Supply switch. In the "O" position the welder is off
Pos. 6 Power connector for HR26 cooling system
25
5