Operating Modes; System Preparation And Power Supply - Aprimatic WING NK Manual De Instrucciones

Operating modes

4. SYSTEM PREPARATION AND POWER SUPPLY

Prepare the electrical connections for the system safety
and control devices as illustrated in the diagram in fi g. 2,
referring to the warnings provided in this Manual. For every
device installed outside the door, prepare suitable cableways
(external or underground) up to the installation point.
!
Warning
The entire system must be created by qualifi ed personnel in full
compliance with the current standards in the country where the
unit is installed.
230VAC POWER SUPPLY - 3x1.5 mm cable (dimension the
cross-section in relation to the length of the line). Prepare the
mains power supply cable on the right-hand (as seen from the
inside). If it is necessary to use automation power supply cable
sheathing, apply this sheathing before connecting the cable itself
to the derivation boxes.
IMPORTANT! Always install, upstream of the line, a mains switch
which guarantees a multipole cut-off with minimum contact
opening of 3 mm (connect it to a 6 A differential overload switch
with sensitivity of 30 mA).
ACCESSORIES The command and control devices and the
emergency button must be positioned within sight of the
automation, away from moving parts and at a minimum height
off the ground of 1.5 m.
Read any other Accessory Device Instructions carefully before carrying
out any operations.
PREPARING THE ACCESSORIES
1
Single beam obstacle detection photocell (ER4N; ER6N)
ER4N external
transmitter: 2x0.75 mm cable
receiver: 4x0.75 mm cable
MAX. distance between transmitter and receiver = 50 m
ER6/N recessed, with amplifier card housed in beam
compartment
11 mm diam. hole - minimum depth 25 mm - cable
supplied (0.25 mm) length 8 m
2 Double beam obstacle detection photocell (ER6N)
ER6/N recessed, with amplifier card housed in beam
compartment
11 mm diam. hole - minimum depth 25 mm - cable
supplied, length 8 m
3 emergency pushbutton (PE)
PE position in view of door - 2x1 mm cable
4 internal emergency manual release (SME/I)
SME/I internal emergency manual release
5 external emergency manual release (SME/E)
SME/E (with pushbutton for 1st opening)
6 passage detection radar (RI3; RI5; DM2)
RI3 Passive infrared radar
RI5 Active infrared radar
DM2 Microwave radar
DM8 Twin microwave and infrared technology radar
(movement+presence)
7 key selector (SC6; SC6EC) or keypad
SC6 or SC6EC
8x0.22 mm cable - MAX. length 15 m
NK multifunction keypad
8 electric lock (EB2)
EB2
cable - length 0.9 m, 1.5 m or 2.5 m
9 Mechanical emergency STOP
STOP device which can be combined with
emergency stop
9
4
5
2
˚
1
˚
3
*
2
˚
- 20 -
Correct functioning of the automation requires the
installation of the control device: Key selector
or Keypad.
Correct use of the electric lock requires that you
pay attention to the effi ciency of the Emergency
batteries. If possible, you can also install the
external emergency manual release SME/E (with
fi rst opening command) and/or internal emergency
manual release SME/I (100% mechanical device).
9
6
2
˚
1
8
˚
2
˚
fi g.2
7
!
OBLIGATORY
6A
230 V ~