Base System Connections (Control Equipment, Power Supply Unit, Batteries, Gear Motor); Wing Nk Control; Accessory Device Connections; Control Devices - Aprimatic WING NK Manual De Instrucciones

System connections
6. BASE SYSTEM CONNECTIONS
The base system components (control unit, power supply unit,
gear motor and emergency batteries) are pre-installed on the
WING NK module and connected to each other.
If replacing any parts, apply the connections illustrated in
Figs. 3-4-5.
Before powering the system, complete the installation with
the accessory devices. Correct functioning of the automation
requires the installation of the control device: Key selector
or Keypad.
When you have fi nished ALL the connections, power the
system by following the indications in STARTING UP.
Information
NEVER remove the unit guard. Failure to comply with this warning
will render the warranty null and void!

6.1 WING NK CONTROL

WING NK CONTROL consists of the electronic control CARD,
secured to an extruded aluminium profi le which acts as SUPPORT
for securing it to the Automation Module. The card is protected
by a guard which has a port for accessing the programming and
signal devices while the terminal boards and connectors are directly
accessible at the sides (fi g.6).
!
Warning
NEVER remove the unit guard. Failure to comply with this warning
will render the warranty null and void!

7. ACCESSORY DEVICE CONNECTIONS

Completion of the installation requires connection of the
accessory devices used within the system. follow the specifi c
diagrams and instructions provided below.
Always make the connections with the power OFF.
Also disconnect the emergency batteries, if present! If a device
is replaced or added after setting-up and starting the system,
apply a system RESET.
!
Warning
All the command and control devices must be positioned within
sight of the automation, away from moving parts and at a
minimum height off the ground of 1.5 m.

7.1 CONTROL DEVICES

7.1.1 Key selector (SC6 - SC6EC)
1 Connect the power supply cable to the numbered Key
selector terminal board, following the colours indicated
in Table 4.
NOTE: to access the Key selector terminal board, refer to the
Key selector instructions.
2 Insert the Selector connector in J7 on the WING NK
CONTROL card (fi g.6).

7.1.2 NK Multifunction Keypad

1 Collegare il cavo di alimentazione alla morsettiera della
Tastiera Multifunzione NK (rispettando i colori indicati
nello schema di tab.5).
2 Collegare la Tastiera alla scheda CONTROL WING NK
inserendo il connettore a 4 poli del cavo di alimentazione
nel relativo connettore J4 della scheda.
NOTA Se la Tastiera Multifunzione NK è il solo dispositivo di
comando installato, è necessario inserire l'adattatore (fornito
nella confezione della tastiera) nel connettore J7 della scheda.
3
4
Power supply unit
F5A
1 2
F20A
F20A ...... card power supply rapid fuse
F5A ........ battery charger rapid fuse
T3,15A ... two delayed primary transformer fuses
EMERGENCY BATTERIES
(-)
(+)
J6
K3

Key selector

Cable colour Terminal number
RED
GREEN
WHITE
PINK
GREY
LIGHT BLUE
BROWN
YELLOW
Tastiera multifunzione
Colore cavo Nr. morsetto
ROSSO
VERDE
BIANCO
NERO
- 22 -
K2
1
2
3
4
2 x
T3,15A
mains power supply
230 V AC ±10%
red +
K1
5
black-
6
(6)
(5)
Table 4
1
2
3
4
5
6
7
8
Table 5
1
2
3
4
fi g.3
fi g.4
fi g.5