Ottobock 1C63 Triton Low Profile Instrucciones De Uso página 15

Ocultar thumbs Ver también para 1C63 Triton Low Profile:
Tabla de contenido

Publicidad

NOTICE
Risk of damage as a result of improper footshell assembly.
Do not use a screwdriver for assembly and disassembly as this can cause damage to the
carbon elements and/or footshell. Otto Bock recommends use of 2C100 Footshell Insertion/
Removal tool (accessories).
NOTICE
Risk of damage as a result of improper use.
The footshell must not be dusted with talcum powder as this would increase abrasion. Use sili-
cone spray for lubrication if needed. Replace the footshell in case it shows any damage or wear.
Inserting the foot into the footshell:
• Attach the tube adapter to the prosthetic foot. This helps, makes it easier to insert the foot into
the footshell.
• Insert the foot into the footshell.
• Make sure the heel of the polymer base spring securely snaps into the footshell heel tab.
Removing the footshell:
• Insert the 2C100 Footshell Insertion/Removal tool under the heel of the polymer base spring
which is located under the heel tabs in the posterior part of the footshell
• Pry the heel out of the shell and pull the foot out of the footshell.
5  Handling
5.1  Alignment
5.1.1  Bench alignment for TT Prostheses
Recommendations on bench alignment (foot with footshell):
Foot size (cm)
21 – 22
23 – 24
25 – 26
27 – 28
29 – 30
For TF Prostheses please follow the recommendations for the alignment of the corresponding
Otto Bock knee joint.
5.1.2  Static alignment optimization
The prosthesis should be aligned with the L.A.S.A.R. Posture, if available. The Otto Bock recom-
mendations on alignment of transtibial and transfemoral prostheses should be observed.
Placement of mid-foot  
anterior to alignment line
36 mm
39 mm
43 mm
46 mm
49 mm
Heel height (mm)
Slim
15
15
10 (24 only)
15
15 (27 only)
Normal
10
10
10
15

Publicidad

Tabla de contenido
loading

Tabla de contenido