Using E On The Remote Control Unit; Switching The Broadcast Audio Channel; Freezing Images - Pioneer PDP-4270XA Manual De Instrucciones

Watching TV

Using e on the remote control unit

• Press e to mute the sound.
e appears on the screen.
Muting
• Press e again or i + to restore the sound.

Switching the broadcast audio channel

Depending on the broadcast, you can switch the audio channel.
Press - to change the audio channel.
•
mode
I II
The table below shows the available audio channels by broadcast
audio type.
1
AAA
Stereo
NICAM STEREO
10:00
2
BBB
Bilingual
NICAM I
10:00
3
CCC
Monaural
NICAM MONO
10:00
4
DDD
Stereo
STEREO
10:00
5
EEE
Bilingual
DUAL I
10:00
6
FFF
Monaural
MONO
10:00
mode MONO mode
MONO
Setting
MONO
1 1
AAA AAA
NICAM STEREO MONO
10:00 10:00
2 2
BBB BBB
NICAM II MONO
10:00 10:00
3 3
CCC CCC
NICAM MONO MONO
10:00 10:00
4 4
DDD DDD
STEREO MONO
10:00 10:00
5 5
EEE EEE
DUAL II MONO
10:00 10:00
6 6
FFF FFF
MONO MONO
10:00 10:00
Note
• In each of the sound multiplex mode selected using the - button,
the display changes depending on broadcasting signals being
received.
• Once the MONO mode is selected, the sound remains mono even
if the system receives a stereo broadcast. You must switch the
mode back to  or  mode if you want to hear stereo sound again.
• Selecting a sound multiplex mode while the input source is INPUT
1 to 4 does not change the type of sound. In this case, sound is
determined by the video source.

Freezing images

Use the following procedure to capture and freeze one frame from a
moving image that you are watching.
Important
• Displaying a static image for a long period of time, or for shorter
periods of time everyday, may result in image retention.
• Press d.
A still image appears on the right screen while a moving image is
shown on the left screen.
Normal image
• Press d again to cancel the function.
Note
• When this function is not available, a warning message appears.
06
Still image
23
En